Intended Use; Environmental Conditions; Obligations Of The Operating Company; Obligations Of Personnel - Fronius TWIN Push Operating Instructions Manual

Intended Use

The device is to be used exclusively for its intended purpose.
The device is intended exclusively for the welding process specified on the rating
plate.
Utilization for any other purpose, or in any other manner, shall be deemed to be
"not in accordance with the intended purpose." The manufacturer is not respons-
ible for any damage resulting from improper use.
Proper use also means
-
-
-
Never use the device for the following applications:
-
-
-
The device is designed for operation in industry and business. The manufacture
shall not be liable for any damage resulting from use in a living area.
The manufacture shall also not be liable for faulty or incorrect work results.
Environmental
Operation or storage of the device outside the stipulated area will be deemed as
Conditions not in accordance with the intended purpose. The manufacturer accepts no liab-
ility for any damage resulting from improper use.
Temperature range of the ambient air:
-
-
Relative humidity:
-
-
Ambient air: free of dust, acids, corrosive gases or substances, etc.
Altitude above sea level: up to 2000 m (6561 ft. 8.16 in.)
Obligations of The operating company must only allow persons to work with the device if they
the Operating
-
Company
-
-
The safety-conscious work of the personnel must be checked regularly.
Obligations of All persons who are assigned to work with the device must do the following be-
Personnel fore beginning the work:
-
-
Before leaving the workplace, ensure that no personal injury or property damage
can occur in one's absence.
Completely reading and obeying all instructions in the Operating Instruc-
tions
Completely reading and obeying all safety instructions and danger notices
Carrying out all the specified inspection and servicing work
Thawing pipes
Charging batteries
Starting motors
During operation: -10°C to +40°C (14°F to 104°F)
During transport and storage: -20°C to +55°C (-4°F to 131°F)
Up to 50% at 40°C (104°F)
Up to 90% at 20°C (68°F)
Are familiar with the basic occupational safety and accident prevention regu-
lations and are trained in handling the device
Have read and understood these Operating Instructions, especially the sec-
tion "Safety Rules," and have confirmed this with their signature
Are trained according to the requirements for the work results
Follow the basic regulations for occupational safety and accident prevention
Read these Operating Instructions, especially the section "Safety Rules," and
confirm that they have understood and will follow them by signing
9