Before Commissioning; Safety; Intended Purpose; Setup Regulations - Fronius VR 4000 Case D200 Operating Instructions Manual

Before commissioning

Safety

Operating the equipment incorrectly can cause serious injury and damage.
► Do not use the functions described here until you have read and completely under-
► Do not use the functions described here until you have fully read and understood all of
An electric shock can be fatal.
If the power source is connected to the mains electricity supply during installation, there is
a high risk of very serious injury and damage.
► Before carrying out any work on the device make sure that the power source mains
► Before carrying out any work on the device make sure that the power source is un-

Intended purpose

The device is intended exclusively for wire feeding in MIG/MAG welding.
Utilisation for any other purpose, or in any other manner, shall be deemed to be not in ac-
cordance with the intended purpose.
The manufacturer shall not be held liable for any damages arising from such usage.
Utilisation in accordance with the "intended purpose" also comprises
-
-

Setup regulations

The VR 4000 Case is tested to IP23 protection, meaning:
-
-
The VR 4000 Case can be set up and operated outdoors in accordance with IP23 protec-
tion. Avoid direct wetting (e.g. from rain).
WARNING!
stood these Operating Instructions.
the Operating Instructions for the system components, in particular the safety rules.
WARNING!
switch is in the "O" position
plugged from the mains
following all the information in the operating instructions
carrying out all the specified inspection and servicing work
protection against penetration by solid foreign bodies with diameters exceeding 12.5
mm (0.49 in.)
protection against direct sprays of water at any angle up to 60° from vertical
33