Base Address Stamping; Base Address Delimiter Character - Datalogic PowerScan 9500 Series Product Reference Manual

Enter/Exit Programming Mode

Base Address Stamping

Enables/disables the ability of base address information to be transmitted to
the host and, if so, at what position with respect to the label data. See
page 304
this feature.
DEFAULT
$CCNAS01(CR)
Base Address Transmission = Prefix

Base Address Delimiter Character

This option specifies the delimiter character to be placed between the label
data and base address when address stamping is enabled.
$CCNAD
Set Base Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
DEFAULT
242
in "References" for detailed information and examples for setting
This feature only applies if
is enabled.
00 = No Delimiter Character
$CCNAS00(CR)
Base Address Transmission = Do Not Include
"Base Address Stamping"
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by two digits from the Alphanumeric
characters in Appendix D, Keypad
your desired character. End by scanning the ENTER/
EXIT bar code again.
~
CANCEL
PowerScan™ PD9530/PBT9500/PM9500
on page 242
representing