Rf Address Stamping; Source Radio Address Transmission; Source Radio Address Delimiter Character - Datalogic Gryphom 4500 Series Product Reference Manual

RF ADDRESS STAMPING

These features allow configuration of source radio data inclusion.

Source Radio Address Transmission

Enables/disables the ability of source radio address information to be transmitted to the
host and, if so, at what position with respect to the label data. See
ences" for detailed information and examples for setting this feature.
$CBTAS00
Source Radio Address Transmission = Prefix

Source Radio Address Delimiter Character

This option specifies the delimiter character to be placed between the label data and
radio address when address stamping is enabled.
Set Source Radio Address Delimiter Character
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
RF ADDRESS STAMPING
NOTE: When included as a prefix, the source-radio ID is displayed after all
label formatting has been applied. The 6 byte hex address is sent as 12
ASCII characters, i.e., an address of 00 06 66 00 1A ED will be sent as
(shown in hex): 30 30 30 36 36 36 30 30 31 41 45 44
NOTE: This feature only applies if " Source Radio Address Transmission" on
page 251 is enabled.
$CBTAD

Delimiter Character = 00 (no delimiter character)
ENTER/EXIT PROGRAMMING MODE

Source Radio Address Transmission =
Do Not Include
$CBTAS01
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
CANCEL
in "Refer-
page 291
represent-
PRODUCT REFERENCE GUIDE
251