In/Out Configuration Item Page - DiGidot C4 Manual

This option limits the individual channels to a specific percentage. This means that every
channel or LED will never exceed this percentage.
E.g.: Limiting brightness to 50%, means that all individual channels can never exceed 50% but
the control range per channel will remain the same. Effectively the percentage is applied to
the input value for each channel.
Adaptive power limiter
‣
This option limits the total average output of all channels combined to a specific percentage in
order to decrease total power consumption. Individual channels may still output up to 100%.
E.g.: Limiting power to 50% means that half of the channels can output 100% and the other
half at 0% or all channels at 50%, etc.
In case you would try to output all channels to 75%, the output of all channels would be
automatically limited to a total 50%, but will maintain ratios relative to each other.
Delete configuration
Deletes all IO configuration settings of selected devices.
In/out configuration item page
Home > Settings > In/out configuration > Universe item
Click on Port D1-D4 to select or change the output protocol. Click on the '+' symbol to add a universe
to each port. Click on a universe item to change following settings.
Channels: Define the number of output channels.
Universe: Assign a universe number as input.
Further configuration options will be shown when you collapse the 'Show advanced settings' option.
Advanced IO config
Start-channel
This option allows you to enter an offset value of the starting channel that this universe listens to. By
entering a start channel (0-511), all channel data before this channel offset will be skipped.
Example
Goal: You want to use channels 100 up to channel 200 as output channel 0-100.
Configuration settings will be as follows:
Start channel is set to 100.
‣
Channels is set to 200.
‣
Explained: First, the start channel will shift 100 channels of the input. This will skip the first 100
channels of the universe. Then set the channels to 200, because 200 channels are required, starting
after the first 100 skipped channels.
C4 Manual Version 2.1.5 53 74 -