Servicing The Bedbar - Toro 03721 Operator's Manual

1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4. Place the angle indicator on the mount as shown
in Figure 30.
Note:
This is the angle that your grinder
produces; it should be within 2 degrees of the
recommended top grind angle.

Servicing the Bedbar

Removing the Bedbar
1. Turn the bedbar-adjuster screws
counterclockwise to back the bedknife
away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer
is no longer tensioned against the bedbar
(Figure 31).
Figure 30
3. Bedknife
4. Angle indicator
(Figure 31).
Figure 31
3. Bedbar
4. Washer
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
1. Bedbar bolt
g034114
4. Remove each bedbar bolt, allowing the bedbar
to be pulled downward and removed from
machine bolt
Note:
Account for 2 nylon washers and 1
stamped steel washer on each end of the bedbar
(Figure 33).
1. Bedbar bolt
2. Nut
Assembling the Bedbar
1. Install the bedbar, positioning the mounting ears
between the washer and the bedbar adjuster.
2. Secure the bedbar to each side plate with the
bedbar bolts (nuts on bolts) and 6 washers.
Note:
Position a nylon washer on each side
of the side-plate boss. Place a steel washer
outside each of the nylon washers
g016647
3. Torque the bedbar bolts to 37 to 45 N∙m (27 to
33 ft-lb).
Note:
Tighten the locknuts until the outside
steel washer stops rotating and end play is
removed, but do not overtighten or deflect the
side plates. The washers on the inside may
have a gap.
17
(Figure 32).
Figure 32
2. Lock nut
(Figure 32).
Figure 33
3. Steel washer
4. Nylon washer
(Figure
g003334
g003335
33).