Dürkopp Adler 868-M Operating Instructions Manual page 72

70
2. Press the pedal to position -2 at the seam end ( p. 80).
 The thread is cut off.
3. Remove the sewing material.
Fig. 47: Remaining thread monitor in action (4)
③
(3) - Milling groove
Important
Insert the new bobbin so that the milling groove (3) is facing down.
4. Changing the bobbin ( p. 44).
 You can start sewing a new seam.
5. Take the remaining thread off the bobbin you removed.
6. If necessary, wind a new hook thread onto the empty bobbin
( p. 41).
Operating Instructions 868-M - 01.0 - 12/2020
Operation