Dürkopp Adler 868-M Operating Instructions Manual page 146

144
Error/
Code Possible cause
warning
2201 Error DA stepper card 2
reference run timeout
2203 Error DA stepper card 2 step
losses
2255 Error DA stepper card 2
overload
3100 Error AC-RDY timeout,
intermediate circuit
voltage did not reach the
defined threshold in the
specified time
3101 Error High voltage fault, mains
voltage > 290 V for an
extended period
3102 Error Low voltage failure
(2nd threshold), mains
voltage < 150 V AC
3104 Warning Pedal is not in position 0 • When switching the
3105 Error U24 V short circuit
3106 Error U24 V (I
3107 Error Pedal not connected
3109 Warning Operation lock
Remedial action
• Check reference
• Check for stiff
• Check for stiff
• Check the mains
• If the mains voltage is
• Check mains voltage,
• stabilize it or use a
• Check the mains
• Stabilize the mains
• Use generator
• Disconnect 37-pin plug
• Replace control if error
• Test inputs/outputs for
2
T) overload • One or several
• Connect analog pedal
• Check tilt sensor on
Operating Instructions 868-M - 01.0 - 12/2020
Troubleshooting
sensor
movement
movement
voltage
OK, replace the control
if nominal voltage is
continuously exceeded
generator
voltage
voltage
control on, take your
foot off the pedal
is not corrected
24 V short circuit
magnets defective
machine