Table of Contents
Advertisement
120
To insert the machine head (2):
1.
Tighten the hinges (1) at the rear of the machine head (2):
• To set up the machine head (2) straight:
Tighten the hinges (1) at the topmost position.
• To set up the machine head (2) slanted:
Tighten the hinges (1) at the bottommost position.
Important
If the machine head is supposed to be set up in a slanted position,
insert the plastic shims into the tabletop cutout ( p. 114).
Fig. 83: Inserting the machine head (2)
2.
Guide the cables through the tabletop with great care so as
not to kink or pinch them.
3.
Insert the machine head (2) vertically into the tabletop cutout.
Operating Instructions 868-M - 01.0 - 12/2020
Setup
Advertisement
Table of Contents
