ABB DSQC1016 Manual page 24

3 Installation of Service Box in Robot Controllers
3.1.3 Mounting instructions
Continued
Alternative 3 mounting
Alternative mounting of the Service box (mounting plate and DIN rail)
For more information, see:
en1600001580
Cable handling
24
• Installation of the Service Box in IRC5 Single and Dual Cabinet on page 25
• Installation of the Service Box in the IRC5P controller on page 28
CAUTION
Be careful,
• When handling the antenna cable. The minimum bending radius is 5 cm.
The cable can be damaged if it is wrongly handled.
CAUTION
When attaching antenna cables, screw the cable tight, but with a torque not
exceeding 0.5 Nm firmly by hand. A higher torque can damage the connector.
© Copyright 2019 ABB. All rights reserved.
Product manual - Connected Services
3HAC060439-001 Revision: E