ABB DSQC1016 Manual page 122

7 Remote Access
7.4 Customer site configuration
Continued
Configure Remote Access connection parameters
The Remote Access connection parameters of Talk2M should be configured in the
service box.
To configure the Remote Access connection parameters of Talk2M from the Service
Box:
To configure the Remote Access connection parameters of Talk2M from MyRobot:
Continues on next page
122
4 In the Features section, select the Enable Remote Access through the
Service Box (Factory:Enabled) check box.
en1600001503
1 Connect to the service box in Config mode.
2 Click Local Setup. The Local Setup window is displayed.
en1600001505
3 Type the Talk2M account credentials in the fields in the Remote Access
Setup section.
4 In the Remote Access Box Name field, type the name of the box which is
visible for the remote access connection. Any name can be chosen which
must be unique for a customer. For example, RSA-BOX-0821-0002-56.
5 Click the Change Configuration button.
The service box reboots and the changes are saved.
Note
If Remote Config is enabled in the User Setup, it will be possible to define the
Remote Access Setup remotely from MyRobot. In this case, the Remote Access
fields will be read only on the Service Box.
1 Connect to the Service Box in Config mode.
2 Click User Setup.
© Copyright 2019 ABB. All rights reserved.
Product manual - Connected Services
3HAC060439-001 Revision: E