Service Work On The Engine 16; Checking The Gear Oil Level; Changing The Gear Oil - GAS GAS MC 50 2022 Owner's Manual

Table of Contents

16.1

Checking the gear oil level

16.2

Changing the gear oil

Warning

Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.

–

Wear suitable protective clothing and safety gloves.

–

In the event of scalding, rinse the area affected immediately with lukewarm water.

Note

Environmental hazard Hazardous substances cause environmental damage.

–

Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-

cable regulations.

Info

Drain gear oil with engine at operating temperature.

Condition

The engine is cold.

Preparatory work

–

Stand the motorcycle upright on a horizontal surface.

Main work

–

Remove screw

–

Check the gear oil level.

A small quantity of gear oil must run out of the drilled hole.

If no gear oil runs out:

–

Add the gear oil.

–

Mount and tighten screw

Guideline

F03034-10

Screw, gear oil level

monitoring

Preparatory work

–

Stand the motorcycle on the plug-in stand on a horizontal surface.

Main work

–

Position an appropriate container under the engine.

–

Remove oil drain plug

–

Let the gear oil drain fully.

–

Thoroughly clean the oil drain plug with magnet.

–

Clean the sealing surface on the engine.

–

Mount and tighten the oil drain plug with the magnet and new seal

ring.

Guideline

F03034-11

Oil drain plug with

magnet