Intercharacter, Interfunction, And Intermessage Delays; Intercharacter Delay; User Specified Intercharacter Delay - Honeywell Voyager 1202G-BF User Manual

Intercharacter, Interfunction, and Intermessage Delays

Some terminals drop information (characters) if data comes through too quickly. Intercharacter, interfunction, and intermessage
delays slow the transmission of data, increasing data integrity.

Intercharacter Delay

An intercharacter delay of up to 327675 milliseconds (in 5ms increments) may be placed between the transmission of each
character of scanned data. Scan the following Intercharacter Delay bar code, then scan the number of 5ms delays, and
the Save bar code using the
To remove this delay, scan the Intercharacter Delay bar code, then set the number of delays to 0. Scan the
using the Programming Chart
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 327675 milliseconds (in 5ms increments) may be placed after the transmission of a partic-
ular character of scanned data. Scan the following Delay Length bar code, then scan the number of 5ms delays, and the
Save bar code using the
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for a printable character to trigger the delay
(see Lower ASCII Reference Table
Delay Length
To remove this delay, scan the Delay Length bar code, and set the number of delays to 0. Scan the
the Programming Chart
Programming Chart inside the back cover of this manual.
Prefix
Intercharacter Delay
Intercharacter Delay
inside the back cover of this manual.
Programming Chart inside the back cover of this manual.
on page A-3).
inside the back cover of this manual.
Scanned Data Suffix
1 2 3 4 5
Save bar code
Character to Trigger Delay
Save bar code using
6 - 5