Intercharacter Delay; User Specified Intercharacter Delay; Interfunction Delay - Honeywell HH1800 User Manual

Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed
between the transmission of each character of scanned data. Scan the Intercharacter Delay
barcode below, then scan the number of 5ms delays from the
on page 211, then Save.
To remove this delay, scan the Intercharacter Delay barcode, then set the number of delays
to 0. Scan the Save barcode from the
Note: Intercharacter delays are not supported in USB serial emulation.

User Specified Intercharacter Delay

An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed after
the transmission of a particular character of scanned data. Scan the Delay Length barcode
below, then scan the number of 5ms delays from the
211, then Save.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for a printable
character to trigger the delay (see
To remove this delay, scan the Delay Length barcode, and set the number of delays to 0. Scan
the Save barcode from the

Interfunction Delay

An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be placed between
HH1800 User Guide
Prefix Scanned Data
1
Intercharacter Delay
Intercharacter Delay
Delay Length
Programming Chart,
Suffix
2 3 4 5
Programming Chart,
Programming Chart,
Lower ASCII Reference Table,
beginning on page 211.
Programming Chart,
beginning on page 211.
beginning on page
)
page 205.
Character to Trigger Delay
beginning
57