Alarm Output As Relay Action; System Settings; Setting The Date And Time - Xylem WTW DIQ/S 281 Operating Manual

DIQ/S 281
ba77244d01
<M>
Pressing hides the alarm messages and switches to the measured value
display. After one minute the alarm messages appear again if what caused them
is still present.

5.6.4 Alarm output as relay action

The relay outputs of the DIQ/S 28X can be configured so a relay action is trig-
gered when an alarm event occurs (Open or Close). For this the Alarm contact
function must be set for the relay output in the Settings of outputs and links.
The Alarm contact function is only available for relays that are not linked with a
sensor. If necessary, an existing link must be erased. For details please refer to
the operating manual of the output module.
5.7

System settings

System settings include:
 Language (see section 5.1)
 Date/Time (see section 5.7.1)
 Location altitude/Air pressure (see section 5.7.2)
 Function code

5.7.1 Setting the date and time

The real time clock is used for the display of date and time in the measured value
display and in log book entries.
1 Open the Einstellungen/Settings menu with
<
2 Using 
System settings -> Date/Time.
The Date/Time display opens.
<
3 Press 
4 Confirm the selection with
A field is highlighted, e.g. Year.
08/2020
> <OK>
and , select and confirm the menu item,
>
to select Set date or Set time.
<OK>
.
Settings/setup
<S>
.
79