Table of Contents
Advertisement
Settings/setup
Menu item
Relay output
Accept
Cancel
Operating
instructions
78
Selection/Values
Dxx / .../Ry
...
...
...
No relay output
5.6.3 Alarm output to display
When an alarm event occurs, a window with a text message appears.
figure 5-10 Example of an alarm message on the display
1 Alarm no. Axx and date and time of the alarm event
2 User-defined designation
3 Sensor number and model name of the sensor that triggered the
alarm event
4 Series number and name of the sensor that triggered the alarm event
5 Description of the event with specification of the limiting value:
"<" = Undercut
">" = Exceeded
If there are several alarm messages indicated on the display, you can scroll
through the messages with
number in the right lower corner. The latest message is always on the first posi-
tion.
Explanations
Opens a list with all relay outputs where
the Alarm contact is set.
Dxx: number of the output module
.../Ry: relay output channel
Here you can select a relay output. When
the alarm event occurs, it carries out the
specified action (Open or Close). For
details, see section 5.6.3 A
.
TO DISPLAY
The settings are taken over in the setting
table by pressing
switches to the next higher level.
The display switches to the next higher
level without storing the new settings.
1
2
3
4
5
<
>
. This can be recognized from the page
DIQ/S 281
LARM OUTPUT
<OK>
. The display
ba77244d01
08/2020
Advertisement
Table of Contents
