Xylem WTW DIQ/S 281 Operating Manual page 36

Installation
Connecting lines
to the terminal
strip
36
1 On the left-hand side of the DIQ/S 28X, remove the two countersunk
screws and open the enclosure.
2
1
3
figure 3-18 Inserting lines
The complete assignment of the terminal strip is shown in
section 3.12.
2 Screw a cable gland (pos. 1 in figure 3-18) with the sealing ring (pos. 2)
into the enclosure below the respective connections.
3 Loosen the coupling ring (pos. 3).
4 Feed the line through the cable gland in the enclosure.
5 Connect the wires to the terminal strip. While doing so, pay attention to
the specifications on the label located under the terminal strip.
6 Tighten the coupling ring (pos. 3).
DIQ/S 281
ba77244d01 08/2020