Connecting The Sensor; Iq Sensor With Snciq Cable - Xylem WTW DIQ/S 281 Operating Manual

DIQ/S 281
General
installation
instructions
Tools
ba77244d01
3.5

Connecting the sensor

The sensor is connected to the SENSORNET connector of the DIQ/S 281.
Lines must always be installed separately at a minimum distance of 20 cm from
other lines that carry a voltage greater than 60 V.
The free end of the sensor cable was stripped in the factory and all the wires are
fitted with wire end sleeves.
 Phillips screwdriver
 Small screwdriver.

3.5.1 IQ sensor with SNCIQ cable

NOTE
The sensor cable may only be connected to the SENSORNET connector. No
wire of the cable may be connected with an external electrical potential. Other-
wise, malfunctions could occur.
1 On the left-hand side of the DIQ/S 28X, remove the two countersunk
screws and open the enclosure.
08/2020
Installation
15