Installation
34
X19
X18
24V AC DC
EINGANG
INPUT
POWER
figure 3-17 24 V AC/DC connection.
The complete assignment of the terminal strip is shown in
section 3.12.
8
Connect wires 1 and 2 to the terminal strip. Make sure that the cable
assignment agrees with the specification on the terminal label under the
terminal strip.
9
Tighten the cap nut (pos. 3 in figure 3-16).
No free wires are allowed to project into the housing. Otherwise there is the dan-
ger of short circuits that can cause a fire. Always cut off any wires that are not in
use as closely as possible to the cable gland.
10
Close the enclosure of the DIQ/S 28X.
DIQ/S 281
ba77244d01
08/2020