Table of Contents
Advertisement
DIQ/S 281
ba77244d01
figure 4-10 Log book of entire system
5
Acknowledge the message with
book entry.
6
Exit the message text with
Acknowledgment of a new message text in the log book marks the
message as read. When all errors or information messages are
acknowledged, the symbols no longer flash.
With the Acknowledge all messages function you can acknowledge all
messages at the same time (see section 4.5.4).
Message texts are stored in the modules that caused them. There-
fore, further information on a log book entry for an IQ sensor such
as, e.g. calibration messages, instructions and help texts are only
accessible in the case of connected components that are ready for
operation.
If a message text is not available because, e.g. a module is not connected with
the system, you can look up the detailed text of the message as follows:
Messages of the system are given in this operating manual (see
section 11.1).
Messages of a module are given in the respective component operating man-
ual of the module.
4.5.4 Acknowledge all messages
1
Switch to the measured value display with
08/2020
<OK>
. A checkmark appears in the log
<ESC>
.
<M>
Operation
.
57
Advertisement
Table of Contents
