Table of Contents
Advertisement
DIQ/S 281
Branches
Relay and current
outputs
Compressed air-
driven cleaning
system
ba77244d01
1
Overview
1.1
Structure and function
One digital single sensor (one sensor for one main parameter) can be con-
nected to the universal transmitter DIQ/S 28X.
This means one main parameter (e.g. pH, D.O., turbidity value...) and one
secondary parameter in addition (e.g. temperature) can be displayed and
administrated.
Each sensor is automatically recognized after being connected and immediately
starts measuring.
The universal transmitter has two relay outputs and two current outputs to be
connected to existing process control systems.
Suitable sensors for the universal transmitter DIQ/S 28X are listed
in the WTW catalog or on the Internet.
The DIQ/JB branching module (accessory) is a simple passive module for the
branching or extending of SNCIQ lines.
The relay- and current outputs can be linked with the sensor. Linked outputs can
be used to monitor sensors and for the output of measured values.
A relay output can be programmed as:
Monitoring relay
Limit monitor
Proportional output of measured values (pulse width or frequency output)
Control unit of a sensor cleaning system driven by compressed air.
A current output can be programmed as:
Analog output
PID controller
The universal transmitter DIQ/S 28X is prepared for the compressed air-driven,
time-controlled sensor cleaning function. For this, a DIQ/CHV valve module and
if necessary a CH cleaning head is required (both available as accessories). The
cleaning procedure is controlled by the Universal Transmitter. The universal
transmitter provides the supply voltage and control relay for the compressed air
valve in the DIQ/CHV valve module. This enables a simple setup and uncompli-
cated wiring.
08/2020
Overview
7
Advertisement
Table of Contents
