Table of Contents
Advertisement
DIQ/S 281
ba77244d01
figure 3-2
SENSORNET connector (example DIQ/S 28X CR2)
5
Connect the cable ends to the terminal strip. At the same time, look out
for the designations of the terminals (red / shield / green).
6
Tighten the cap nut (pos. 3 in figure 3-1).
7
Close the enclosure.
The complete assignment of the terminal strip is shown in
section 3.12.
For further instructions on the mounting of the sensor at the applica-
tion location, please refer to the relevant manual (immersion depth,
etc.).
3.5.2 IQ sensor with permanently mounted cable
NOTE
The sensor cable may only be connected to the SENSORNET connector. No
wire of the cable may be connected with an external electrical potential. Other-
wise, malfunctions could occur.
1
On the left-hand side of the DIQ/S 28X, remove the two countersunk
screws and open the enclosure.
08/2020
X3
X2
X1
SENSORNET
black
green
red
Sensor
Installation
17
Advertisement
Table of Contents
