Independent Source/Tracking Generator - Keysight B Series User Manual

SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)
SA Mode Settings
Volume Control
To increase or decrease the Volume of the demodulated signal:
— Press Meas Setup 4
— Then
— Enter a value in percent between 0 and 100 (loudest) using the numeric
— Volume can also be changed and easily muted from the System menu.
Demod ON and OFF
To quickly stop the audio demodulation and perform only the normal SA
sweeps, select the following:
— Press Meas Setup 4
— Then

Independent Source/Tracking Generator

For best results, when using the independent source feature, InstAlign and
the battery saver features should be turned off. Refer to
Individual Alignments" on page 148
This feature may require an option. For a comprehensive list, view the FieldFox
Configuration Guide at:
http://literature.cdn.keysight.com/litweb/pdf/5992-3701EN.pdf
A tracking generator, a popular option with Spectrum Analyzers, is a source
which always tracks the SA receiver.
Like a traditional tracking generator, the Independent Source feature can set
the internal FieldFox source to track the SA receiver frequency range. It can
also set the internal source to a CW frequency that is independent of the SA
frequency.
Independent Source can be enabled ONLY when the FieldFox is in SA mode.
To view the internal source, you must connect a cable or device between the
RF Output connector and the RF Input connector.
How to make Independent Source Settings
— Press Measure 1
— Then
—
126
Volume
keypad, arrows, or the rotary knob.
Learn more in "How to set the FieldFox Volume Control" on page
Demod ON OFF
Source
Source Enable ON OFF
— ON Turns ON the internal source.
"How to Access
and "Preferences" on page
Keysight N9938-90003 User's Guide
219.
230.