Frequency Reference; How To Set The Frequency Reference Settings; File Folders; How To Set File Folders - Keysight B Series User Manual

System Settings

Frequency Reference

Frequency Reference
When Internal or External is selected, a search is made for satellites overhead.
GPS (default) works best when outdoors and in full view of the open sky.
See also,

How to set the frequency reference settings:

This procedure saves your frequency reference settings using the Quick
Settings Table in Preferences. Learn more in
page
1. Press System 7 >
2. Press
3. Use arrow keys
4. Press
5. Choose from the following:

File folders

When enabled, FieldFox uses the last selected Device and Folder location as the
default device location after instrument power cycle.
Before setting the preferences for the File Folders, you must select the
Device and Folder locations. Refer to

How to set File Folders

— Press System 7
238
"GNSS (GPS+) and GPS" on page
230.
Preferences
until
Next Page
or knob to scroll down to until
highlighted.
Edit > Frequency Ref Sou [GPS]
— GPS - (default setting).
— External
customer-supplied, USB dongle device. A check is made
to detect a USB GPS device at the USB connectors.
— Internal
Connect a GPS antenna to the top-panel GPS connector.
Learn more about additional GPS antenna accessories at
http://www.keysight.com/find/fieldfox. Internal is set
automatically when Frequency Reference Source is set to
GPS. Learn more in
page 250.
245.
"Quick Settings Table" on
> Preferences
is displayed.
Frequency Reference
then
- Enable GPS using an external,
- Enable GPS using Option 307 – Built-in GPS.
"Frequency Reference Source" on
Chapter 10, "File Management."
Keysight N9938-90003 User's Guide
then
Frequency Ref Source
is