Power On - Keysight B Series User Manual

System Settings
System Configuration
For all FieldFoxes with firmware ≤A.08.18 and ≤A.09.50 FW, when using
Static IP addresses:
— Static Subnet Mask - Enter the Subnet Mask – including periods - in the
— Static Gateway - Enter the Static Gateway – including periods - in the
— Static DNS - Enter the Static DNS – including periods - in the format
— Apply Settings Choose from:
To make the LAN settings persist after power up, toggle Apply Settings to
Now then back to Power Up. You should see a message indicating that the
LAN config file was saved.
— Press

Power ON

When the FieldFox is without a power source, this setting allows the FieldFox
to power ON as soon as a charged battery or the DC Adapter is inserted
without pressing the power button.
How to set Power ON
— Press System 7
— Then
— Then
— Then
— Then choose from the following:
256
— Static - Set the IP Address manually. The Address remains until you
change it.
— Static IP Address - Enter the IP Address – including periods - in the
format nnn.nnn.nnn.nnn
— Either a valid Static Gateway is required or 0.0.0.0.
— Either a valid Static DNS is required or 0.0.0.0. (If entry is available.)
format nnn.nnn.nnn.nnn
format nnn.nnn.nnn.nnn
nnn.nnn.nnn.nnn
— Power Up The above settings take effect when the FieldFox is
started.
— Now The above settings take effect immediately.
Done Edit when finished.
System Configuration
More
Power ON
— Auto The FieldFox will power ON when a charged battery or the DC
Adapter is inserted.
Keysight N9938-90003 User's Guide