Preset; How To Preset The Fieldfox; User Preset - Keysight B Series User Manual

System Settings

Preset

Preset
The Preset key restores the FieldFox measurement settings to a known
condition. You can preset the entire instrument, or just the current Mode (CAT,
SA, and so forth).
When Preset, the FieldFox CalReady calibration is recalled for use in CAT and
NA Modes. Learn more in
In addition to all Preference settings, the following settings always survive
Preset and Mode Preset:
— External Reference state (see
— SA Scale and Units (see
— SA Correction states (see
— VVM Display Resolution (see
— Marker Peak Excursion and Threshold (see

How to Preset the FieldFox

— Press Preset.
— Then choose one of the following:

User Preset

User Preset allows you to store custom settings for each mode, then recall the
settings when the Preset key is pressed. Your custom settings are saved to a
standard State file (UserPreset.sta). However, unlike State files, calibration
data is NOT saved. Learn more ab0out State files in
Device" on page
Keysight N9938-90003 User's Guide
— Single Automatically sets Continuous OFF (Hold) and causes
FieldFox to make ONE measurement sweep, then hold for the next
Single key press.
— SA Mode ONLY – With
press also causes a single sweep.
— Continuous ON OFF
setting when battery power is not critical.
— Preset Returns ALL Modes to the factory default settings.
— Mode Preset Returns only the current Mode to the factory default
settings. The current settings for all other Modes remain.
271.
Continuous OFF
Makes continuous sweeps. This is the typical
"CalReady" on page 89.
"Frequency Reference Source" on page
"Scale and Units" on page
"Field Strength Measurements" on page
"Display Resolution" on page
"What Is a 'Peak'" on page
each successive Run/Hold
115)
119)
524)
"Set File Type and Select
250)
201)
217