Install Slot Filler Covers; Remove Modules - Rockwell Automation Allen-Bradley 1715-AENTR User Manual

Chapter 2 Installation Instructions

Install Slot Filler Covers

Remove Modules

112
Table 15 - First Module in TA Group
1715-IB16D, 1715-OB8DE, and 1715-IF16 Modules
Indicator
Module Status
Redundancy Status
Network Status
Channel 0...7, 8...15
8. If the module is installed next to other modules that are already online,
the start-up sequence completes.
When startup is complete, the status indicators light as follows.
1715-IB16D, 1715-OB8DE, 1715-IF16 Modules
Indicator
Module Status
Redundancy Status
Network Status
Channel 0...7, 8...15
If the module fails to go online, see the troubleshooting guide in
Chapter 9.
To install the slot filler covers, follow these steps.
1. Place a slot filler cover on the empty slot.
2. Screw the clamp screw 90° to the lock position by using a 9 mm
screwdriver.
Module Status
Redundancy Status
Network Status
Rack Status
Ethernet 1
Ethernet 2
Reset
Modules can be removed online without shutting down the system or
upsetting the process in redundant configurations only. However, pulling out
simplex module impacts the process.
Rockwell Automation Publication 1715-UM001J-EN-P - December 2020
1715-OF8I Module
Status Indicator
Green Module Status
Green Redundancy Status
Amber Network Status
Off Channel 0...7
1715-OF8I Module
Status Indicator
Green Module Status
Green Redundancy Status
Green Network Status
Inputs show Green;
Channel 0...7
Outputs show Amber
TERMINAL IDENTITY
CH1 CH1 CH1 CH1
CH1 CH1 CH1 CH1
AOTA
Dual.
Module Status
Redundancy Status
Network Status
Rack Status
Ethernet 1
Ethernet 2
Reset
Status
Green
Red to steady green
Amber
Off
Status
Green
Red to steady green
Amber
Inputs show Green;
Outputs show Amber
Slot Filler Covers
32078 M