Configure The Redundant I/O System; Before You Begin; Install The Software; Install The Add-On Profiles - Rockwell Automation Allen-Bradley 1715-AENTR User Manual

Before You Begin

Install the Software

Install the Add-on Profiles

Configure the Redundant I/O System

Topic
Install the Software
Install the Add-on Profiles
Create the Project in RSLogix 5000 or Studio 5000 Logix Designer
Add the 1715-AENTR Adapter to the I/O Configuration Tree
1715-IB16D Digital Input Module
1715-OB8DE Digital Output Module
1715-IF16 Analog Input Module
1715-OF8I Analog Output Module
Now that the hardware portion of the system is installed, you can configure
your 1715 Redundant I/O System by using the software applications that you
installed from the Product Compatibility and Download Center at
rok.auto/pcdc. See
Before you begin configuring the 1715-AENTR modules in the redundant
chassis, verify that these tasks have been completed:
• Make sure that RSLogix 5000® programming software, version 20 or
later, or Studio 5000® environment, version 21 or later, is installed.
• Make sure that the drivers are installed by using RSLinx® Classic
software, version 2.57 or later.
• Make sure that the firmware is at the latest revision and the software is at
the latest version.
• Make sure that both Add-on Profiles are installed on your system:
- One for the 1715 adapter
- One for the 1715 I/O modules
Install the following software:
• RSLogix 5000 programming software, version 20 or later, or Studio 5000
environment, version 21 or later
• RSLinx® Classic software, version 2.57 or later
You must install two Add-on Profiles — one for the adapters, version 2.01.014
or later, and one for each of the I/O modules, version 3.01.014 or later. (The four
I/O module Add-on Profiles are contained in one file.)
Rockwell Automation Publication 1715-UM001J-EN-P - December 2020
System Software on page
Chapter
Page
157
157
160
165
177
185
189
193
59.
6
157