Overview - Clutch Release Mechanism - Volkswagen Golf 2015 Repair Manual

1.4

Overview - Clutch Release Mechanism

1 - Clutch Slave Cylinder with
Release Bearing
❑ Must be replaced to‐
gether because they are
a single unit
❑ Do not wash the bear‐
ing, just wipe it off.
❑ Replace a loud bearing
together with the clutch
slave cylinder
❑ Removing and instal‐
ling. Refer to
⇒ 1.11 Clutch Slave
Cylinder with Release
Bearing, Removing and
Installing , page 33
❑ For release bearing with
additional plastic wash‐
er. Refer to
⇒ Fig. Release Bear‐
ing with Additional Plas‐
tic Washer ,
page 22 , pressure
plate allocation. Refer to
⇒ Fig. Only for Re‐
lease Bearings with Ad‐
ditional Plastic Washer;
Where the Pressure
Plate Diaphragm
Springs -arrows- have a
Slightly Lower Installa‐
tion Height. ,
page 22
❑ Allocation. Refer to the
Parts Catalog.
2 - Bolt
❑ For metal clutch slave
cylinder (without locking
fluid): 12 Nm
❑ For plastic clutch slave cylinder (with locking fluid): 15 Nm
❑ Replace after removing
❑ Quantity: 3
❑ Pay attention to the thread pitch on the bolt when cleaning the threaded hole in the clutch housing.
❑ Carefully tighten diagonally and in step so that the tabs on the clutch slave cylinder do not break
3 - Clamp
❑ To remove and install the line, remove the clip up to the stop
❑ Install until the clip engages audibly
4 - Line
❑ To the clutch master cylinder
5 - O-Ring
❑ Replace if damaged
❑ Install on the line connection
❑ Install with brake fluid
❑ Allocation. Refer to the Parts Catalog.
.
Golf 2015 ➤ , Golf Variant 2015 ➤
Manual Transmission - Edition 02.2016
21
1. Clutch Mechanism