Table of Contents
Advertisement
5700P Series Power Operator
Final Electrical and Mechanical Setup
1.
Confirm all mechanical adjustments have been
made and wiring connected.
2.
Turn on facility's main circuit breaker.
3.
Turn on power at On/Off switch and flip breaker
switch to "RESET". (Figure 29)
4.
Using a short jumper cable, jump terminals 1 and
2 to activate unit. When door reaches 20°, flip
Breaker Switch to "OFF" position cutting power
to unit. Allow door to fully close (door may be
manually pulled closed). (Figure 30)
5.
Adjust Closing Position Magnet (Figure 31)
• With door in closed position, use finger to slide
Closed Position Magnet so it aligns directly with
Reed Switch.
6.
Adjust Open Position Magnet - Use fingers to slide
Open Position Magnet 180° from Open Position
Magnet.
7.
Flip Breaker Switch to "RESET" to turn power on.
8.
Jump terminals 1 and 2 to activate door. Note open
position of door. Allow door to close.
9.
Use finger to readjust Open Position Magnet to
desired door open position.
10. Repeat Step 7 to verify door open position.
11. Make all connections necessary for any accessories
to 4-position Accessory Terminal.
See Wiring Section.
12. Make necessary adjustments to inverter.
See Inverter Details Section.
You've now installed the 5700P Operator - PULL SIDE or PUSH SIDE.
Continue with Electrical Instructions to customize the installation.
Copyright © 2016, 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9357-0009-020 Rev 7 01/20
WARNING: 120VAC power supplied to operator must
be a dedicated circuit from the main circuit breaker
panel and must NOT be connected into any building
lighting system that operates fluorescent lights.
Approved 2020-01-27
Figure 29
Figure 30
Figure 31
13
Advertisement
Table of Contents
