Cut Pushbar (If Required) - Assa Abloy Corbin Russwin ED8200A Series Installation Instructions Manual

ED8200A Series
Fire-Rated Rim Exit Device
Installation Instructions
3 Preparation (cont .)
c

Cut Pushbar (If Required)

Note
If bar does not require cutting, proceed to step 4a.
A. Installation of device depends on trim: Note 3/4" (19 mm) minimum restriction. (Figure 3)
B. Measure and mark bar as shown. (Figure 4)
C. Fully depress bar and cut off square on mark. (Figure 5)
3/4" (19 mm) Min.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2011, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Cut off point
Figure 3
Door width minus
5" (127 mm)
Figure 4
4
Pushbar
must
be fully
depressed
Figure 5
FM124B 04/20