PED5200 & PED5200 A Series
Rim Exit Device for 10T, 55T, 42, & 42T Functions
Installation Instructions
Tools Needed
Before installation:
1. Install mullion, if used.
2. Fit and hang door.
3. Check the box's label for the size of the exit device.
4. For wood doors, use wood screws and prep accordingly.
The surface of the door where the exit device is to be applied must be flush. Clear away any
raised projections to allow exit device to rest on the flat surface of the door. If shim kit is
required, contact your distributor.
Note: Please refer to trim and other installation instructions provided in the box.
DOOR HANDS DETERMINED FROM OUTSIDE OF DOOR
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved.
Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited.
OR SECURED SIDE
Support Block (Provided)
Rail Cutting Guide (Provided)
3
FM576 9/22