Advertisement
PED5400 FE & PED5400 A FE Series
Surface Vertical Rod Exit Device
Installation Instructions
Tools Needed
Before installation:
1. Install mullion, if used.
2. Fit and hang door.
3. Check the box's label for the size of the exit device.
The surface of the door where the exit device is to be applied
must be flush. Clear away any raised projections to allow
exit device to rest on the flat surface of the door. If shim kit is
required, contact your distributor.
Handing
To Change Hand of a PED5401 Exit Device:
1. Remove both chassis pins and main slide.
2. Remove lift lever pin and lift lever.
3. Rotate chassis 180° and reposition lift lever and lift lever pin as shown below
4. Position main slide with large end of main slide at the bottom and retain with chassis pins.
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2023, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited. Patent
pending and/or patent www.assaabloydss.com/patents.
Lift lever
Main slide
Right Hand
Large end
Reverse
Support Block (Provided)
Rail Cutting Guide (Provided)
Chassis
Lift lever pin
Chassis pin
Left Hand
Reverse
Note: Please refer to trim and
other installation instructions
provided in the box.
THIS EXIT DEVICE IS HANDED
CHECK HAND OF DEVICE AGAINST APPLICATION
OUTSIDE
RIGHT HAND
REVERSE
BEVEL
INSIDE
Lift lever
Main Slide
Large end
4
LEFT HAND
REVERSE
BEVEL
FM612 01/23
Advertisement
