Table of Contents
Advertisement
If you have not already completed the instructions on the Quick Start packed with your iPBridge, use
the following instructions to install the iPBridge.
Unpacking the packing box; verifying
contents
• The iPBridge
Note the serial number of your iPBridge,
located on the bottom of the unit, for later use:
______________________________
• Serial cable
• Power cord
• "L" brackets and screws
• CD which includes the Installation and Operation
Manual, the firmware, ATTO QuickNAV and
ATTO drivers
Placing the iPBridge into your system
1
Place the iPBridge on a stable flat surface or
install it into a standard rack.
If installing into a rack, see Exhibit 2.0-1.
a. Attach brackets so that the front side with
the LEDs face front and the connector side
is at the back.
b. Install the iPBridge horizontally within the
rack so it does not reduce the air flow within
the rack.
2
Connect the host computer to Fibre Channel
devices.
3
Power up the Fibre Channel devices.
4
Connect the iPBridge Ethernet port on the host
computer to your network using at least Cat5e
cable.
5
Connect the AC power cord from the iPBridge
to the proper AC source outlet.
CAUTION
CAUTION
The power source must be connected to a
protective earth ground and comply with
local electrical codes. Improper grounding
may result in an electrical shock or damage
to the unit.
If installing into a rack note that the power
requirements plus the power draw of the other
equipment in the rack must not overload the
supply circuit and/or wiring of the rack.
6
Turn on the power switch on the iPBridge.
7
Wait up to two minutes for the iPBridge Ready
LED to light indicating the bridge has completed
its power-on self test sequence.
7
ATTO Technology Inc. iPBridge Installation and Operation Manual
2 Installation
8
Windows
Windows
Discovering the IP address
Installing Windows drivers
1
Windows automatically detects the iPBridge
and asks for the driver in the Add Hardware
wizard. Select Install from a list or specific
location
2
Click Next
3
Choose Don't Search
4
Click Next
5
Choose Have disk
6
Specify the driver as found in the PC folder in
the setup CD. The files are in a folder based on
your operating system. Use the files directly
from the CD or copy them onto a floppy or to a
local directory on your hard drive.
7
Follow the remaining instructions to complete
the installation procedure.
8
After the driver is installed, the iPBridge is listed
in the System Devices folder.
Discovering the IP address
1
From the CD supplied with your iPBridge, run
the QuickNav Utility QuickNAV-windows.exe
for Windows or QuickNAV-Mac for OS X.
2
Locate the iPBridge with the serial number
recorded earlier.
3
Highlight the serial number.
4
Click Next.
If a DHCP server is available on your network,
an address is assigned automatically by the
server. Note the assigned address:
_____________________________________
If you do not have a DHCP server, get an IP
address and subnet mask from your network
administrator, type it into the area provided, and
select Next. Note the IP address and subnet
mask here._____________________________
5
Click on Launch Browser
Windows users continue to
Initiator for
Installing iSCSI Initiator for OS
If you use Internet Explorer, use
Internet Explorer
®
users continue to
Installing
®
drivers; Mac
users continue to
Installing MS iSCSI
Windows; Mac users continue to
X.
Setting up
if needed.
Advertisement
Table of Contents
