Al Location Of Feeder Functions - Passap ELECTRONIC 8000 Operating Manual

Actions d u ri n g kn itti ng
Al location of feeder fu nctions
I n the techniques i s programmed which feeder i s to be used for which row. ( See
also page 2 1 ) This makes it possible to control, that there is always the right
feeder in the carriage.
The general rule is the following:
1 color techniques are knit with feeder number 1
2 color techniques are knit with feeders number 1 + 2
3 color techniques are knit with feeders number 1 , 2 + 3
4 color techniques are knit with feeders number 1 , 2, 3 + 4
The feeders are numbered starting from the left.
Should one of the feeders be inoperative for some reason, instead of being unable
to knit the chosen technique you can change the feeder allocation as
If you work normally with all feeders the display is the
FEEDER
t 1 t
FEEDER
1
FEEDER
2
FEEDER
3
4
92
FEEDER
FEEDER
�
FEEDER
FEEDER
It is possible to block one or more of the feeders
When the corresponding input field is activated press
CLR
Now this feeder cannot be used anymore until you type
again the original number in the now empty input field.
Note
: If the blocked feeder is not number 4 it is necessary
change the allocation of the feeder functions, to make the
best possible use of the remaining
following·
• 1 +
•2 +
• 3 +
+
•4+
feeders.
follows:
:
to