Knitting A Pattern Sector - Passap ELECTRONIC 8000 Operating Manual

Kn itting a pattern sector
The program now asks you to enter the knitting width, regardless of whether you
have set the absolute row counter to zero or whether you have selected the
"knitting pattern sector
If you wish to alter the knitting width during knitting, you can access this display by
pressing the EDG key. Please refer also to page 90.
v
L
EDGE
v
EDGE R
EDGE MOTOR
EDGE MOTOR R
L "
EDGE
EDGE R "
ENT
zero" .
t-1 92+
. 1 91 +
·-1 92+
L
. 1 91 +
+
+-1 92+
. 1 91 +
Here you can determine the width you wish to knit.
The first two numbers refer to the knitting width of the front
bed.
You must enter something here, unless you want to knit, as
provided for by the program, over the full bed width.
The edges for the back bed and for the motor
automatically adapt to what you have entered here.
If you are sure that everything is the way you want it, press
ENT now.
+
KNIT s
53