Passap ELECTRONIC 8000 Operating Manual page 80

P rog ra m m i n g a pattern sector
Prog ra m m i n g , when the control unit is not attached to the
kn itti ng machi ne.
78
This might be necessary, when you want to transfer a pattern
from a PC, that is not near the knitting
At the control unit unplug the cable that goes to the motor
and unplug the transformer from the mains. Bring the control
unit together with the transformer to where you want to
program.
Plug the cable of the transformer to the mains.
The first display will be the same as when you start the
machine with the control unit attatched to it.
Now you can press the key
ProgS
Program as usual.
The only difference will be, that when you have finshed
programming there will be no useful row information.
0 ??
It will always be
machine.
0
and SECTOR