Passap ELECTRONIC 8000 Operating Manual page 182

E rror messages
4080, 4081 ,
4082, 4083
4 1 2 3
41 40
41 73
41 81
1 52
MODULE ERROR
The defragmentation has not been possible. Unplug the
plug from the operating unit and plug it in
If the same error message appears again, replace your
module by another.
N OT ENOUGH SPACE
There is not enough space left in the module for the pat­
tern you want to programme or to save. Delete some pat­
terns and defragment the module. (See page 99)
NO DATA TRANSFERRED
The E 8000 has not received any data from the PC. Have
you pressed a random key on the PC ? If yes check whe­
ther the connecting cable is plugged in properly.
WRONG CAM BOX POS.
The carriage was still moving while you pressed a key
that i s not active in this
C H ECK MOTO R
The motor i s switched off or the cable of the motor i s not
plugged in.
If this is not the case the fuse might be broken. Unplug the
cable goint to the mains. There you wil l find a small dra­
wer, that can be pulled out. Nearer to the motor is the ac­
tive fuse, that might be broken. Nearer to you is a reserve
fuse. Push it sideways out of its holding and put it in the
place of the broken fuse.
again.
situation.