Changing The Knitting Width - Passap ELECTRONIC 8000 Operating Manual

Actions d u ri n g kn itting
C h a n g i n g the kn itting width
If, during knitting, you would like to change the knitting width or the travel of the
motor, you can do this by pressing the EDG key. This key is only active when the
motor is not running.
E D G E L v
EDGE R v
E D G E MOTOR L
E D G E MOTOR R
E D G E L A
E D G E R A
ENT
or
ENT>
90
�-1 9 2 +
- 1 91 +
t-1 9 2 +
..
+ -1 9 2 +
+ 1 91 +
You can change the knitting width here by overwriting the
actual numbers, just as you would when beginning a knitting
in sector zero. (Refer to page 53)
The procedure is identical, i.e. when you change the edges
for the front, the edges for the back and for the motor are
automatically adjusted
cursor to the corresponding place of entry, you may,
enter another value
.
When you are satisfied with all displayed values, press ENT.
Then the display STOP AT appears.
Here you can enter a single stop as described on page 89.
If you would like to skip over this display, press the ENT> key
You are now back to where you were when you pressed the
EDG key.
correspondingly. If you move the
however,