Passap ELECTRONIC 8000 Operating Manual page 51

Sta rti n g t h e k n itti n g m a c h i n e
E N T
The cam box i s in its start position when it i s on the right-hand
end plate. When you face the machine, the last needle of the
needle bed should be visible on the left-hand side of the cam
box.
(Note: the cam box must not be actually in the colour changer
on the right-hand side . )
When you press the GO/STOP key, the cam box will
automatically move to its start position and stop there.
Confirm that the cam box is in its start position by
pressing the ENT key.
If the cam box is already In the start position, just press
The actual starting process is completed when you
confirm the START POSITION by pressing the ENT key.
If you press the GO/STOP key with the cam box in STARTPOSITION ,
he 1 st feeder ready to be taken into the cam box and before you have
ENT
pressed the key, the cam box will move over the full bed width
forward and backward.
If you now bring needles in work position and set the cam box to
mechanical knitting functions
having anything programmed. Please refer also to page xxx
(N, CX, EX), you can start knitting without
.
49