Passap ELECTRONIC 8000 Operating Manual page 49

Sta rting the kn itting mac h i n e
ENT
In general, at this point you will choose among the following
three possibilities:
1 . You wish to conti nue you r piece of
knitting at the poi nt where you have
switched off the machi ne.
If this is the case, press ENT. The knitting instructions
following now are described on the following page.
2 . You wish to start at row zero a piece of
kn itti ng which you have a l ready
programmed.
In this case enter a zero at the first input point, then press
ENT. The instructions relating to starting a new piece of
knitting at the zero row will appear.
3. You wish to program a sector or eve n
an entire piece of knitti n g .
Also in this case enter a zero at the first input point and then
press ENT.
When the next display appears, you can press the " ProgS"
key which a llows you to reprogram one or several pattern
sectors.
(In principle it is possible to press the "ProgS" key at this
point. If you do this, enter zero first in any case. Otherwise
the operating unit will always calculate the pattern up to the
number of rows indicated here, and this takes time
depending on the pattern and the number of rows).
.
47