Table of Contents
Advertisement
E rror messages
3 1 22
3 1 2 3
3 1 24, 3 1 25,
3 1 26
3 1 35
3200
3203
3205
3207
1 48
The machine cannot be started, as one of the tension
arms touches the yarn breakage device.
Bring the tension arm into a position where it does not
happen and start again.
The GO/STOP key is jammed in the position where it is
down. Free the key and start again.
The slider that fixes the cam box to the motor cannot be
directly opposite one of the edge stops.
The switch of the motor is in the "off' position.
Set it to " ON " and
re-start.
YARN BREAK
Fix the yarn again and thread up properly. Make sure that
the tension arm does not touch the yarn breakage
OVE RHEAT
The motor is
overheated.
cooled
down.
M OTOR BLOCKED
This message appears when the motor is blocked on a
part of the needle bed, where the cam box should be
knitting. Set everything in order and continue.
If you have to push the cam box in the wrong direction to
free it, do not forget to press the "change direction " key
first.
Here might appear the message " unravel 1 row " or
" unravel 2 rows " . In that case do not forget to set the row
counter back. (See page 1 44)
FEEDER ERROR
This message appears when the cam box has been in the
color changer and has taken the wrong feeder (i.e. not
the one demanded by the technique) or no feeder, when
there should be one, or vice versa.
Press ENT and automatically the direction of the cam box
points again to the color changer.
Set the color changer in a way that the cam box will take
over the correct feeder.
Wait until it has sufficiently
device.
Advertisement
Table of Contents
