Passap ELECTRONIC 8000 Operating Manual page 86

The a u x i l ia ry rows
Trans ition rows for cast ons that are not knitted with a l l
needles.
Transition rows before cast on 1 for 1 : 1
All needles and jacks will
remain in working position.
The cast on wi be made
I I
only on these needles.
84
When you have completed a double bed fairisle
knitting with all needles and you would like to begin a
new knitting with a cast on for 1 : 1 , you cannot simply
release the stitches not needed for the cast on. This
would lead to dropped stitches in the previous
knitting. To avoid this, use following techniques.
Knits with feeder 4 as follows:
2 rows all stitches front and back
4 rows only stitches on front bed
2 rows all stitches front and back
4 rows only stitches on front bed
2 rows all stitches front and back
2 rows without yarn, this releases the stitches on the
front bed.
2 rows all stitches on back bed
only every second stitch on front bed
4 rows stitches only on back bed
2 rows all stitches on back bed
only every second stitch on front bed
4 rows stitches only on back bed
2 rows all stitches on back bed
only every second stitch on front bed
2 rows without yarn, this releases the stitches on the
back bed.
If you have pressed "KnitS" 2 rows in advance, the
needles of the back bed are also pre-selected for 1 :
(In case you have forgotten to press 2R before the
"KnitS" key, you do not need to set the cam box to SX
for the preparation rows. Technique 20 is programmed
in a way that the cam box will automatically move over
the needles without selection.)
20
1 .