Table of Contents
Advertisement
Error messages
4020, 4021
4023, 4026
4024, 4026
4026
4027 , 4033
4030
4031
TEC H N IQUE I NVALID
The programme cannot read the technique any more. Try
unplugging the plug from the operating unit and plug it in
again. Then programme the sector again with the same
technique. If this does not work contact the nearest
service center and indicate the number that has been
displayed.
v PATTERN
The pattern for the front bed has more colors per row of
squares than can be knitted with the chosen technique.
It may also mean that the pattern is larger that what can
be knitted on your machine.
If the pattern has not too many colors check if no feeder
has been blocked by pressing the COL
92)
"PATTERN
The same as 4023 but in relation to the pattern of the
back bed.
TOO MANY COLORS
See 4023
FEEDERS BLOCKED
One or more feeders have been blocked (by using the
COL key, see page 92 ). Therefore there are no more
enough feeders available to knit the programmed
technique.
NO DATA
The operating unit does not have access to the necessary
data any more. It might be that you are knitting too quickly
and the operating unit cannot complete the necessary
calculation.
Knit more slowly or set the length of the motor travel
wider. (See page 54)
TOO MANY COL CHANGES
In all 1 0 pattern sectors together too many color changes
occur (Maximum 255 ). Set one or more pattern sectors to
default.
key.
(See page
1 49
Advertisement
Table of Contents
