Changing To Another Pattern Sector - Passap ELECTRONIC 8000 Operating Manual

Kn itting a pattern sector
Chang i ng to another patte rn sector
KnitS
SECTOR
KNI TT ING
SE CTOR DEFAULT
ENT
You can change from any pattern sector to any other at any
time.
The following steps differ slightly from those you have to
follow when you start to knit the ZERO PATTERN SECTOR
with the row counter reading being zero:
The question asking for the knitting width will not appear,
because the program assumes that you have already started
your knitting.
The two preparation rows are not knitted with the cam box
settings SX/SX. The necessary preparations for the new
pattern are made while the two last rows of the previous
pattern sector are being
If you wish to knit any patter
key.
The " KNITTING SECTOR" disp
Enter the number of the secto
Press the ENT key.
knitted. ( See page 60 to 61 )
n sector, press the " KnitS"
lay appears .
• 1 .
r which you wish to knit.
59