Table of Contents
Advertisement
T h e fa bric ta kedow n
Setti ng of the fabric takedown
28
The screw for adjusting the take off force
With this you can ad
the knitting.
To increase, turn the screw cockwise. The
amount of thread showing in the centre can be
used as an indication of how much pull-down
force has been set.
To start always begin with as little force as
possible. If you notice that the stitches are not
being knitted to your satisfaction, increase the
take-off force.
Basic rule:
The take-off force must be greater for a knitting
piece which progresses rapidly than for a
knitting piece which progresses slower.
The take-off force must be greater for a wide
knitting piece than for a narrow knitting piece.
The screws for the pressure rollers
This is to control the pressure where the knitting
is pressed against the takedown roller. Turn the
screws clockwise to increase the pressure.
Basic rule:
The greater the take-off force, the greater the
pressure must be.
j
ust the pull-down force on
Advertisement
Table of Contents
