Passap ELECTRONIC 8000 Operating Manual page 56

Knitti n g a patte rn sector
ENT
54
Please note: a minus preceding a number means that the
needle is on the left seen from the middle of the needle
you only want to knit on the right-hand side of the bed,
from needle 1 0 to needle 1 00 on the right, then overwrite the
number in the first line with 1 0 and delete the minus sign by
pressing the "-" key (= minus).
To reactivate the minus sign, press the minus key again.
In the 3rd and 4th line you can set the length of motor travel.
The entry can only exceed the knitting width you entered for
the front bed.
This is an advantage if you want the cam box to travel a little
further beyond the edge of the knitting than originally
programmed.
( If you try to enter a length of motor travel that is smaller than
the knitting width, there wil l be an error message . )
The 5th and 6th line allow you to enter numbers other than
those entered in the 1 st and 2nd line
If all input fields have the correct entries, press the ENT
key.
( Unless you press ENT>,to skip the STOP AT display)
bed.
e.
.
KNIT s
If
g.