Passap ELECTRONIC 8000 Operating Manual page 22

T h e color c h a n g e r
20
Press the first black key corresponding to the
first feeder from the left right down until it clicks
into place.
Press the main lever down until the first feeder
support from the left swings up.
Remove the feeder from its support and thread it
with the yarn coming from the first tension arm
from the left.
Fit the feeder into its support again, holding the
yarn at the same time.
Note: replace feeder into its support with its two
rings between the two clamps.
Press the feeder down. Guide the end of the yarn
down between the needle beds and fasten
Thread the yam through feeder 2, 3 and 4 in
the same manner.
Finally, press discharge flap, the AUTOCOLOR
is now in Neutral Position. The discharge flap i s
underneath the AUTOCOLOR to the back of the
small rectangular box.
it.