Fuses - ETC ArcSystem Pro Multi-Cell RDM Installation Manual

CAUTION:
around the entire luminaire enclosure. Clean using compressed air or a soft
cloth. Keeping the components of the enclosure clean facilitates efficient
cooling and extends LED longevity.
NEVER spray liquids into the luminaire.
NEVER spray compressed air into a luminaire that is powered-up.
Note:
replaced only by a qualified technician. Contact ETC Customer Support for assistance.
A can of compressed air or oil-free air from an air compressor set at a low setting can be used to
blow through the vent holes and remove dust or other debris. Dust buildup can cause
overheating and premature shutdown.
All components can be cleaned using compressed, oil-free air as described above or a clean
micro-fiber cloth. The use of any liquid cleaning solution is not recommended.
Inspect all mounting hardware for wear and, if necessary, clean using compressed, oil-free air or
a soft, lint-free cloth.

Fuses

Some ArcSystem luminaires have a user-serviceable fuse located in the power switch. Consult
the table below for your luminaire type. All emergency luminaires, 100–277 V luminaires, and
luminaire types that are not listed do not have user-serviceable fuses.
Voltage
100–240 V
36
Check for excessive dust or debris in the heat-dissipating fins
The light sources in this luminaire are not user-replaceable, and must be
Luminaire
Pro Two-Cell
Pro Four-Cell Square
Pro Four-Cell Linear
Pro Four-Cell Round
Pro Eight-Cell
Fuse
Quantity
1 3.150 A, 250 V, class T 5x20 mm
Fuse
ArcSystem Pro Multi-Cell Installation Guide