Complete Installation; Installing A 100-277 V Emergency Four-Cell Pendant - ETC ArcSystem Pro Multi-Cell RDM Installation Manual

5. Terminate line (hot) to the Sense input.
a. Locate the WAGO connector on the line (hot) wire (black) from the input labeled
Sense.
b. Run a line (hot) wire (typically brown, orange, or yellow) through conduit to a free
position on the WAGO connector.
c. Lift up the orange clip, insert the line wire, and press the clip down onto the wire.
d. Tug gently to make sure the wire is secure.
6. Continue by connecting DMX (see
installation.

Complete Installation

1. Connect DMX (see
2. Check that all wires are terminated properly and secure in their terminals.
3. Tuck wiring inside the wiring compartment and replace the wiring compartment cover
using the screws set aside previously.
4. Rotate the luminaire so it is roughly focused to its final resting position. This will assist in
final focus procedures.
Installing a 100–277 V Emergency Four-Cell Pendant
With the exception of input power terminations, emergency Four-Cell Pendant fixture
installation requirements are the same as those of the standard Four-Cell Pendant fixture.
Complete the installation as follows, referencing
page 14
for installation details.
100-277V Four-Cell Pendant Components:
The emergency pendant ships with a two-wire twisted red and black harness for sense input as
shown in the illustration at
Installing 100–277 V Emergency Multi-Cell Luminaires
Terminate DMX on page 13
Terminate DMX on page 13
100–277 V Four-Cell Pendant Components on page 15
), then complete the
).
Installing a 100-277 V Four-Cell Pendant on
.
27